Publicidad
Idiomas disponibles
Idiomas disponibles
INOXPAN S.L. Pando
ELECTRICAL INSTALLATION
ATTENTION!
QUALIFIED INSTALLER OR SAT PANDO ONLY
CAUTION!
THE ELECTRICAL INSTALLATION OF THE OVEN MUST BE CARRIED OUT BY A
QUALIFIED INSTALLER OR A SPECIALIST OF THE PANDO TECHNICAL SUPPORT SERVICE. IF ANY
DAMAGE OCCURS DURING THIS PROCESS THAT HAS BEEN CARRIED OUT BY AN UNQUALIFIED
USER OR PERSONNEL, IT WILL NOT BE COVERED BY THE WARRANTY, EVEN IF IT IS STILL VALID!
Position A shows the location of the terminal box on the rear of the outer casing.
• To connect the furnace to the mains, the installer must use a power supply cable type
H05RR-F, H05SS-F or H07RN-F. The connection diagram is shown
• The oven must always be connected to a good earth connection in accordance with
current regulations.
• The connection must be made through an omnipolar switch, suitable for the current to
be withstood and with a minimum opening between contacts of 3 mm for disconnection
in cases of emergency, cleaning or lamp replacement. Under no circumstances may the
earthing cable pass through this switch.
• This switch can be replaced by a plug, provided that it is accessible in normal use.
• Any manipulation or repair of the appliance, including the replacement of the power
cable, must be carried out by authorised service personnel using original spare parts.
Repairs or handling carried out by other persons may cause damage to the appliance or a
malfunction, endangering its safety.
• Switch off your oven when it is out of order.
• In combination ovens with a hob, only those recommended by the manufacturer may be
fitted.
Interpretation of power supply
wires:
1. Brown or Black = Line/Phase (L)
2. Blue = Neutral (N)
3. Green/Yellow = Grounding
53
PHT-861
PHTV-862
PHP-864
X
EN
Publicidad
