Roger Technology B70/1DCHP/S1 Instrucciones Y Advertencias Para El Instalador página 59

7
Function buttons and display
UP
DOWN
PROG
• Press the UP and/or DOWN
•
• Press and hold the + or -
• To save the new value, wait a few seconds or move onto another parameter with the UP
•
8
Switching on or commissioning
Power the control unit.
Version installed H1.02.
Immediately afterwards, the displays enters the commands and safety device status mode. See chapter 9.2.
9
Display function modes
9.1
Parameter display mode
See chapter 11 for detailed descriptions of the parameters.
TEST
buttons to view the parameter you intend to modify.
VALUE
BUTTON DESCRIPTION
Next parameter
UP
Previous parameter
DOWN
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Travel acquisition
TEST Activate TEST mode
or DOWN button.
59