Publicidad
Idiomas disponibles
Idiomas disponibles
14
Safety input and command status (TEST mode)
DISPLAY
POSSIBLE CAUSE
The release handle is open.
(Sb)
The safety STOP contact is open.
Sensing edge COS1 not connected
or incorrectly connected.
Sensing edge COS2 not connected
or incorrectly connected.
Photocell FT1 not connected or in-
correctly connected.
Photocell FT2 not connected or in-
correctly connected.
If occurs with no voluntary com-
mand, the contact (N.O.) may be
faulty or one of the buttons may be
incorrectly connected.
If occurs with no voluntary com-
mand, the contact (N.O.) may be
faulty or the timer may be incorrectly
connected.
N.B: press TEST to exit TEST mode.
We recommend troubleshooting safety device and input status errors with "corrective action by software" only.
ACTION BY SOFTWARE PHYSICAL CORRECTIVE ACTION
Close the release handle and turn the
-
nected correctly.
-
Set the parameter
if
not used or to disable
Set the parameter
if
not used or to disable
Set the parameter
e
if not used or to
disable
Set the parameter
e
if not used or to
disable
-
tions to buttons.
-
tions to buttons.
-
tions to buttons.
-
tions to buttons.
must not be jumpered if not used.
-
Install a STOP button (NC) or jumper
Jumper contact COS1 with contact
Jumper contact COS2 with contact
nection referring to relative connection
diagram.
nection referring to relative connection
diagram.
-
-
-
-
-
-
-
75
Publicidad
