Publicidad
Idiomas disponibles
Idiomas disponibles
16
TEST
x5 s
INFO mode may be used to view certain parameters measured by the B70/1DCHP/S1 controller.
Press and hold the TEST button for 5 seconds from the "View command signals and safety devices" mode with
the motor stationary.
Parameter Function
.
View for 3 s
.
sorption.
mains voltage = 230 V AC (nominal), bUS=
mains voltage = 207 V AC (-10%), bUS=
mains voltage = 253 V AC (+10%), bUS=
or completely closed position, if the control unit detects a strain higher than the value stored in its memory during
Display current threshold, expressed in Amperes, at which the obstacle detection function (crush prevention) of
ters
and
For the motor to function correctly,
E.g. .
= 1 s / .
If the control unit is capable of identifying the position of the gate when the test is conducted, the following is
Indicates the state of the automation system (open/closed).
automation system opening (motor active).
automation system closing (motor active).
automation system completely open (motor not actives).
automation system completely closed (motor not actives).
mains voltage too low or overload.
motors overcurrent.
Displays the number of thermal protection interventions of the inverter. If it displays a number different from 0000,
from the mechanical stop.
Displays information about the electronic voltage limiter (ROGER TECHNOLOGY's TECHNICAL ASSISTANCE
ONLY).
• Use the + / - buttons to scroll through the parameters. When the last parameter in the sequence is reached,
press the - button to return through the previous parameters.
• In INFO mode, the automation system may be activated to test operation in real time.
• Press and hold the TEST button for a few seconds to exit INFO mode.
78
= motor installed on the left
.
.
.
must always be lower than the value
= 0.12 s (120 ms). Ensure that the manoeuvre time is more than 0.3 s.
,
,
and
...
;
= motor installed on the right
.
.
TEST
TO QUIT THE
INFO MODE
).
.
, in seconds.
1 click
-
-
Publicidad
