Publicidad
Idiomas disponibles
Idiomas disponibles
9.3
TEST mode
To activate the mode, press the TEST button with the automatic door system at rest. If the gate is moving, pressing
TEST stops the gate. Pressing the button again enables TEST mode.
safety device is activated.
No safety device in alarm state and no limit switch activated.
(Sb)
STOP contact (N.C.) open.
If there is no STOP switch, jumper the contact.
If sensing edge is not installed, disable with
edge is not installed, disable with
not installed, disable with
not installed, disable with
NOTA
alarm for the next device is displayed. Any further alarm states are also displayed with the same logic.
Press the TEST button again to exit test mode.
After 10 seconds with no user input, the display returns to command and safety device state display mode.
9.4
Standby mode
POWER
The command signal status is shown on the left hand side of the
display for 5 seconds, ONLY when the respective command signal is
active (
,
,
,
,
activated, the letters AP appear on the display.
The status of the safety devices/inputs is shown on the right hand
side of the display. The number of the terminal relative to the safety
.
.
.
This mode is activated after 30 minutes with no user input. The POWER
Press UP
, DOWN
, + , - to reactivate the control unit.
NOTE: If a safety password (only if active) is unlocked, to adjust the
parameter settings, the password is automatically reactivated in
Stand By mode.
). For example, if the gate open command is
.
61
Publicidad
