Roger Technology B70/1DCHP/S1 Instrucciones Y Advertencias Para El Instalador página 63

10.2
Acquisition procedure:
PROG
AP P-
x4 s
OPENING OPEN
• Press and hold PROG for 4 seconds.
• Open the release handle. The message
launches a calibration procedure. The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
• Close the release handle. The acquisition procedure now starts.
• is shown on the display (only if parameters
photocell beam within 5 s, to prevent interrupting the procedure.
• is shown on the display and the gate starts opening at low speed.
•
• The gate closes until it reaches the complete maneuver.
•
.
If the acquisition procedure is completed successfully, the display enters the command and safety device state
display mode.
•
• acquisition error
• travel length error
For more information, see chapter 15 "Alarms and faults".
PH A5
PH A5
Wait ...
AU to
is shown on the display.
appears on the display after a few seconds. The controller unit
,
FO TO
(if FT are connected
or enabled)
CLOSING CLOSE
, , are not disabled). Keep away from the
AU to
Yes
63