Roger Technology B70/1DCHP/S1 Instrucciones Y Advertencias Para El Instalador página 62

10
Travel acquisition
For the system to function correctly, the gate travel must be acquired by the control.
10.1
Before starting
HIGH SPEED Motor
SELECTION
FIXED BG30/1800/HS
1. Select the position of the motor relative to the gate with the parameter
is with the motor installed on the right hand side of the gate (seen from interior side).
OPENING ON THE LEFT
2.
OPEN CLOSE
3.
4. Press TEST
safety devices are not installed, jumper the relative contact or disable the device from the relative parameter
( , , , , and
TEST
1 click
CLOSE
62
MOTOR
MODEL
TYPE
OPENING ON THE RIGHT
).
TEST
17
No
TEST
da ta
No
YES
TEST
00
CONFIGURATIONS
up to 1800 see chapter 13 "Special Parameters for
High Speed Motor"
. The default setting for this parameter
).
SEE CHAPTER 14 and 15
1 click
Until ...
PROG
AP P-
1 click
Press and hold on
ACQUISITION
PROCEDURE
CHAP. 10.2
1 click
ACQUISITION
PROCEDURE
CHAP. 10.2