Descargar Imprimir esta página

Roger Technology B70/1DCHP/S1 Instrucciones Y Advertencias Para El Instalador página 77

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 143
PROBLEM
The gate does not
open or close.
(btLO)
Acquisition procedure
does not complete
correctly.
Remote control has
limited range and does
not work while auto-
mated gate is moving.
not working.
Gate open indicator
lamp does not work.
Gate does not perform
desired manoeuvre.
N.B.
The next time a command is received, the alarm reappears on the display if the problem has not been resolved.
ALARM
POSSIBLE CAUSE
Encoder calculation error.
Inverter thermal overload circuit Function is restored automatically within 2 min.
Flat batteries.
Release device open.
Problems with the encoder cir-
cuit or on the connecting cable. Disconnect and then reconnect from main power.
TEST button pressed acciden-
tally.
Safety devices in alarm state.
Excessive voltage drop.
Incorrect setting of parameters
and
.
Travel length error.
length exceeded
The radio transmission is im-
peded by metal structures and
reinforced concrete walls.
Flat batteries.
light wires disconnected.
nected.
Incorrect setting of parameter
.
Incorrect selection of the bat-
tery type.
ACTION
Repeat acquisition procedure.
Wait for mains power to be restored.
connected correctly.
Repeat acquisition procedure.
ting the encoder to the motor.
Contact technical support in case of any pro-
blems.
Give a command (opening/step-by-step, ... ).
If
does NOT appear, repeat the learning
procedure.
If
appears again contact the technical as-
sistance.
Repeat acquisition procedure.
device/s in alarm state and the connections of
the safety devices.
Repeat acquisition procedure.
Adjust parameters
and
weight and speed of the gate leaf.
repeat the procedure.
Reset default controller unit parameters and repe-
at the procedure.
crease the length
Reduce the ride. Contact technical assistance
(travel exceeding the maximum allowed by the
technical characteristics)
Install the antenna outside.
Replace the transmitter batteries.
-
Select the correct installation position with para-
meter
.
Change the value of the parameter
-
correctly for the
-
.
77

Publicidad

loading