Publicidad
Idiomas disponibles
Idiomas disponibles
STOP. The gate stops and remains stationary until the next command is received.
photocell is cleared.
DELAYED REVERSE. The gate stops if the photocell is obstructed. The gate opens when the photocell is cleared.
Photocell (FT2) mode with gate closed
This parameter is not visible if
If the photocell is obstructed, the gate cannot open.
The gate opens when an open command is received, even if the photocell is obstructed.
The photocell sends the gate open command when obstructed.
Enable close command 6 s after activation of photocell (FT1-FT2)
N.B.: This parameter is not visible if
opening, the 6 secs. count starts when the wings are completely open.
Disabled.
Enabled. When the photocell barrier FT1 is crossed, a close command is sent 6 seconds later.
Enabled. When the photocell barrier FT2 is crossed, a close command is sent 6 seconds later.
Setting motor stop distance
01= faster deceleration/shorter stop distance ... 05= slower deceleration/longer stop distance.
Selecting installation position of motor relative to gate (seen from interior side)
NB:
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when opening.
NC contact (normally closed). The gate always reverses.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when closing.
NC contact (normally closed). The gate always reverses.
PARTIAL OPENING
OPENING
CLOSING.
STOP.
Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the remote
control is active. The parameter
70
,
or
appears on the display, then repeat the acquisition procedure (see chapter 10.2).
COS1
COS2
is ignored.
or
is set.
is set. NOTE:
Publicidad
