cecotec Power Espresso 20 Barista Maestro Manual De Instrucciones página 36

ENGLISH
NOTE:
you can exit the descaling cycle at any time by pressing the power button.
STEP 1 Start descaling
- Turn the steam/hot water knob to the hot water position.
- Press the double espresso button or the single espresso button.
- The pump will start, and hot water will come out of the extraction head and steamer. For a
period of 2 minutes the pump will make different noises, this is normal.
- When no more hot water comes out of the extraction head and the steamer, the machine
will beep once to indicate that this step has been completed.
- Turn the steam and hot water knob to the vertical OFF position.
- Repeat the above operation releasing the hot water from the extraction head and steamer.
STEP 2 Preparation for the cleaning
NOTE
: it is necessary to clean the steamer and extraction head with cold filtered water to
remove the descaling solution.
- Remove the water tank and rinse it under running water, making sure that all traces of the
descaling solution have been removed.
- Fill the water tank to the MAX mark with cold filtered water and insert it into position.
- Empty the water from the containers and replace them.
STEP 3 Start the cleaning
- Turn the steam/hot water knob to the hot water position.
- The pump will start, and hot water will come out of the steamer.
- Repeat the above operation releasing the hot water from the extraction head and steamer.
STEP 4 Descaling completed
- Once descaling has been completed, you must deactivate this function.
- Turn the steam and hot water knob to the vertical OFF position.
- Press and hold the power button, the single espresso button, the double espresso button,
and the steam button simultaneously for 3 seconds.
- The machine exits the descaling setting and returns to the READY state.
- Empty the water from the containers and clean them, making sure that all traces of the
descaling solution have been removed.
70
POWER ESPRESSO 20 BARISTA MAESTRO
5. TROUBLESHOOTING
Troubleshooting the coffee machine:
Problem Cause
The coffee machine The coffee machine is not plugged
does not work in correctly.
properly
Acid (vinegar) taste in You have not properly cleaned the
coffee coffee machine with cold purified
water to remove the descaling
solution.
The coffee bean is stored in a
warm and humid place for a long
time. Coffee beans spoil.
Water seeps out of There is too much water in the
the bottom drip tray.
The sealing gasket of the water
inlet orifice is deformed.
Coffee machine breakdowns.
When the water tank is removed
after use, it is normal for some
water to remain on the table.
Ticking sounds after The sounds are caused by the
switching on the water pump operating normally.
machine and tearing
sounds after pouring
the coffee
ENGLISH
Solution
Plug in the coffee machine
correctly.
Clean the machine properly
after descaling.
Store ground coffee beans
in a cool, dry place. After
opening a bag of ground
coffee, reseal it and store it in
a refrigerator to keep it fresh.
Clean the drip tray.
Contact the official Technical
Support Service of Cecotec.
As the water outlet at the
bottom of the water tank is a
moving part, it is normal for
it to drip. Dry it each time you
remove the tank.
It is normal.
POWER ESPRESSO 20 BARISTA MAESTRO
71