cecotec Power Espresso 20 Barista Maestro Manual De Instrucciones página 37

ENGLISH
The coffee machine The coffee beans are not the right
makes coffee with ones.
little flavour
The size of the coffee beans is too
coarse.
The amount of coffee beans is not
appropriate.
The coffee beans are pressed very
lightly.
The temperature is not suitable
for brewing coffee.
The amount of espresso is
inappropriate.
Problem Cause
The filter holder is The silicone gasket on the
too tight to rotate the extraction head is new and
extraction head needs to be fitted.
You have used too much coffee
beans.
The filter holder is The filter holder is not fitted
loose or comes out correctly or has not been
during espresso tightened sufficiently.
extraction
The filter is not inserted in the
filter holder.
The silicone gasket on the
extraction head is damaged or
worn.
72
POWER ESPRESSO 20 BARISTA MAESTRO
Use mixed coffee beans.
Use finer coffee beans.
Not enough coffee beans, use
more coffee beans.
Press harder.
Make sure the temperature
is correct (92~96 °C/198~205
°F).
Approximately 30 ml per
dose.
Approximately 60 ml per
dose.
Solution
Continue to use the machine
normally. This gasket will settle
during the first few uses and
become easier to turn.
Use less coffee beans.
Make sure that the filter holder
tabs are fully inserted into the
extraction head and rotated to
the centre position.
Be sure to insert a filter into the
filter holder before inserting it
into the extraction head.
Contact the official Technical
Support Service of Cecotec.
Espresso drips or Coffee grind is too fine.
drips down the side
You have used too much coffee
during extraction
beans.
Over-pressed ground coffee.
The upper edge of the filter has
not been cleaned and coffee
residues remain.
The silicone gasket inside the
extraction head is dirty.
The silicone gasket on the
extraction head is damaged or
worn.
The filter holder is not installed
properly.
Both outlets of the filter holder
are blocked.
Filter holes are clogged.
Problem Cause
The espresso has The coffee bean is old or dry.
no crema, or the
crema is thin (low
The ground coffee is too
extraction)
coarse.
Not enough ground coffee is
used.
The coffee has not been
sufficiently pressed.
Too much or too little Customisable tap volumes are
espresso volume used.
ENGLISH
Switch to a coarser grind setting.
Use less coffee beans.
Apply less force during pressing.
Clean around the top edge of the
filter before inserting it into the
extraction head.
Wipe the parts with a damp cloth.
Contact Customer Service.
Install it correctly.
Clean the outlets.
Soak the filter in water for half an
hour and clean it with a brush.
Solution
Use fresh coffee beans of
medium or dark roast.
Switch to a finer grind setting.
Use more ground coffee.
Press harder.
Restore the default shot volumes
or change your custom volumes.
POWER ESPRESSO 20 BARISTA MAESTRO
73