Kärcher B 50 W Manual De Instrucciones página 21

Malfunction
DOSE version only: The detergent
dosing device does not work
The waste water drain hose is clogged 1. Open the dosing unit cover at the drain hose.
Malfunction
INSERT KIK
INCORRECT KIK
NO AUTHORISATION
RELEASE HANDLE SWITCH!
BATTERY LEVEL LOW
BATTERY EMPTY
WATER FLOW FAULT
DRIVE MOT. OVERL.
DRIVE MOT. BLOCK.
A: Packaging unit, B: Quantity required by the device
Description
Roller brush, red (medium, standard)
Roller brush, white (soft)
Roller brush, orange (high / low)
Roller brush, green (hard)
Roller brush, black (very hard)
Microfiber roller
Pad roller shaft
Roller pad, yellow (soft)
Roller pad, red (medium)
Roller pad, green (hard)
A: Packaging unit, B: Quantity required by the device
Description Part no.
D 51
Disc brush, natural color 4.905-027.0
(soft)
Pad, red (medium soft) 6.369-079.0
Pad, green (medium hard) 6.369-078.0
Pad, black (hard) 6.369-077.0
Melamine pad 6.371-025.0
Orbital melamine pad -
Microfibre pad 6.371-271.0
Disc brush, white 4.905-028.0
Disc brush, red (medium, 4.905-026.0
standard)
Disc brush, black (hard) 4.905-029.0
Diamond pad fine, green 6.371-240.0
Rectification
1. Check the detergent level in the detergent canister.
2. Increase the detergent dosage.
3. Check the connection of the detergent hose to the detergent canister.
4. Clean the filter in the detergent canister.
5. Check the check valve in the hose to the cleaning head for blockage.
6. Check the hoses for leaks.
7. Check the functionality of the detergent pump.
2. Pull the suction hose off the suction bar and close it by hand.
3. Set the program switch to a programme with suction.
The blockage is sucked out of the drain hose into the waste water tank.
Malfunctions with information shown on the display
Cause
No intelligent key inserted.
The inserted Intelligent Key does not authorise the execution
of the selected function.
The inserted Intelligent Key does not authorise the execution
of the selected function.
When the device is switched on, a driving lever is operated.  Release both driving levers.
The battery is almost empty. The cleaning functions of the de-
vice are automatically switched off.
The battery is empty. The cleaning functions and the travel
drive are switched off.
The electric water valve is defective.
The current consumption of the driving motor is too high.
The driving motor is blocked.
Cleaning head with roller brushes accessories
Part no. Description
4.035-184.0 Red standard roller brush for maintenance cleaning.
4.762-409.0 White roller brush for cleaning sensitive floor coverings.
4.762-410.0 Orange roller brush with high-low structure for particularly effective cleaning of struc-
tured floor coverings.
4.762-411.0 Green abrasive roller brush for basic cleaning and for removing strongly adhering dirt. 1
4.762-412.0 Black, particularly abrasive roller brush for basic cleaning of insensitive floor cover-
ings with particularly adherent dirt.
4.114-010.0 Ideal for fine stone tiles. Microfibre roller for reliable and gentle removal of grey film. 1
4.762-415.0 Pad roller shaft made of aluminium to accommodate roller pads or microfibre rollers. 1
6.369-732.0 Yellow roller pad for cleaning and polishing non-textured floor coverings.
6.369-734.0 Red standard roller pad for maintenance cleaning of non-textured floor coverings.
6.369-733.0 Green abrasive roller pad for basic cleaning as well as for removing strongly adhering
soiling on non-structured floor coverings.
Cleaning head with disc brushes accessories
D 60 O 51
4.905-016.0 -
6.369-826.0 6.369-079.0
6.369-827.0 6.369-078.0
6.369-828.0 -
6.369-828.0 6.371-025.0
- 6.371-365.0
6.369-958.0 6.371-271.0
4.905-015.0 6.370-273.0
4.905-014.0 -
4.905-017.0 -
6.371-233.0 6.371-240.0
Rectification
 Insert an intelligent key.
 Use a different Intelligent Key.
 Possibly have the Intelligent Key used activated (depending on
the case).
 Use a different Intelligent Key.
 Possibly have the Intelligent Key used activated (depending on
the case).
 Drive the device to the charging station and charge the battery.
 Switch off the device, wait briefly and switch it on again. The drive
to the charging station. If necessary, push it to the charging station
when it is switched off. Charge the battery.
 Contact customer service.
 Check the travel drive train for foreign objects.
 Find a path with a lower gradient.
 Switch off the device, wait briefly, switch the device on again.
 Check the travel drive train for foreign objects.
 Jack up each drive wheel individually and check whether it can be
turned.
Accessories
Description
Natural-coloured, soft disc brush for cleaning and pol-
ishing textured floor coverings.
For cleaning all floors.
For cleaning heavily soiled floors and for basic cleaning.
For stubborn soiling and for basic cleaning.
For interim and basic cleaning of microporous surfaces
such as porcelain stoneware and other hard floor cov-
erings. Can also be used to remove grey film.
For interim and basic cleaning of microporous surfaces
such as porcelain stoneware and other hard floor cov-
erings. Can also be used to remove grey film.
For reliable and gentle removal of grey film. Particularly
suitable for maintenance cleaning of porcelain stone-
ware tiles.
White soft disc brush for gentle cleaning of sensitive
floor coverings.
Red standard disc brush for regular maintenance
cleaning.
Black very abrasive disc brush for basic cleaning of in-
sensitive floor coverings with particularly adherent dirt.
Green fine diamond disc pad for polishing floor cover-
ings that can be polished. Enables high-gloss surfaces
and can also be used for crystallisation.
English
A B
1 2
1 2
1 2
2
1 2
2
2
20 40
20 40
20 40
A B
D 51 D 60 O 51
1 1 2 -
5 1 2 1
5 1 2 1
5 1 2 1
2 1 2 -
2 - - 1
5 1 2 1
1 1 2 -
1 1 2 -
1 1 2 -
5 1 2 1
21