Seca 604 Instrucciones De Uso página 116

Message
005-318XX-XXX
006-318XX-XXX
010-318XX-XXX
019-318XX-XXX
020-318XX-XXX
022-318XX-XXX
050-280XX-XXX
052-280XX-XXX
053-280XX-XXX
12.5 Restarting the device (seca 495/495 r)
116 • seca 604, seca 495/495 r/496, seca 404/405, seca 446/448, seca 442, seca 438, seca 476
Cause
Barcode invalid or damaged
Patient ID/user ID not found
Unable to transmit measurement to
EMR System
Update failed
Overcurrent at USB interface of weigh-
ing platform
No connection to
seca connect 103
software
Overcurrent at USB interface of display
Internal device communication error
Communication error between weigh-
ing platform and display
In individual cases (e.g. following implausible input) it may be necessary to
restart the device. To do so, you can switch the device off and back on again or
interrupt the power supply and then restore it.
NOTE
All the individual settings in the device are retained in the event of a
restart. If you want to reset the device to factory settings, proceed as
described in the relevant section:
Remedy
Use a valid, undamaged barcode
In EMR system:
• Create patient file
• Create user account
Check settings in the
seca connect 103
software
• Restart update
• If the error recurs, inform seca Service
• Check connected USB device
• If the error recurs, do not use the USB
device
• Repeat measurement
• Check settings in the
seca connect 103
software
• Restarting the device
• If the error recurs, inform seca Service
• Check connected USB device
• If the error recurs, do not use the USB
device
• Restarting the device
• If the error recurs, inform seca Service
• Restarting the device
• If the error recurs, inform seca Service
è Factory settings, page 77