Publicidad
Idiomas disponibles
Idiomas disponibles
Taring additional weight (Tare)
84 • seca 604, seca 495/495 r/496, seca 404/405, seca 446/448, seca 442, seca 438, seca 476
NOTE
– If the
Autohold
cally displayed permanently as soon as stable measured values have
been achieved
(è Activating Autohold
– If you wish to update measured values (weight and height), press the
display field or press the
Weight
repeated and the updated measured values are displayed perma-
nently.
Device mode
Basic
Advanced
Expert
Service
Use the
Tare
function to prevent an additional weight (e.g. a towel) from affect-
ing the patient's weight.
NOTICE!
Faulty measurement as a result of force shunt
If an additional weight, (e.g. a large towel) contacts the surface on
which the scale is placed, weight will not be measured correctly.
► Make sure that additional weights are only placed on the scale's
weighing platform.
✓
There is no load on the scale.
1. To activate the
function, proceed as follows:
Tare
a) Place an additional weight (here: 1 kg) on the weighing platform.
b) Press the
Tare
key.
c) Wait until the value
1. Weigh the patient.
2. Read off the measured result.
ð The additional weight is deducted automatically.
3. To deactivate the function, proceed as follows:
a) Remove the weight from the weighing platform.
b) Press the
key.
Tare
function is activated, weight and height are automati-
function, page 93).
key again. The measurement is
Hold
Function available
0.00
and the message
NET
–
•
•
•
are displayed.
Publicidad
