Publicidad
Idiomas disponibles
Idiomas disponibles
5.21
Connecting a barcode scanner (optional)
2. Insert the display into the display holder.
A barcode scanner can be connected to the USB interface of the weighing plat-
form.
The barcode scanner is required for the following functions:
•
: Define network data in the
Configuration
transfer them to the device using the QR code
tions, page 101
•
Operation
: Record patient and user IDs for transmitting measuring results to
è Completing the measurement, page 89
an EMR system
•
: Scan additional weight with a barcode and have it automatically
Operation
deducted from a measuring result, e.g. the weight of a wheelchair
additional weight with barcode, page 86
WARNING!
Injury
► Route the connector cable so that patients cannot become caught
or strangle themselves in it.
► Route the connecting cable so as to prevent patients and users
tripping.
NOTICE!
Damage to device
► The USB port should be used only for barcode scanners and RFID
scanners that are supported by seca.
NOTE
► Observe the maximum permitted current consumption of the bar-
code scanner.
► Use only barcode scanners recommended by seca.
► The device is compatible with NFC/RFID scanners. For details,
contact seca Service.
To connect a barcode scanner, proceed as follows:
1. Ensure that the device is disconnected from the power supply.
software and
seca connect 103
è Setting up network func-
è Saving
Starting up device • 53
English
Publicidad
