Parker AC30 Serie Manual Del Producto página 360

D-68
Parameter Reference
Parameter Name No.
Actual Speed rps 0394
This parameter changes according to the Control Strategy:
•
In Vector Control mode the parameter shows the calculated mechanical speed of the motor shaft in revolutions per second.
•
In Volts-Hertz Control mode, the parameter shows the motor synchronous speed in revolutions per second.
Actual Speed Percent 0395
This parameter changes according to the Control Strategy
• In Vector Control mode the parameter shows the calculated mechanical speed of the motor shaft as a percentage of the user
maximum speed setting (100% Speed in RPM in the Scale Setpoint function).
• In Volts-Hertz Control mode, the parameter shows the electrical drive output frequency as a percentage of the user maximum
speed setting (100% Speed in RPM in the Scale Setpoint function).
DC Link Volt Filtered 0396
This shows the filtered voltage across the dc link capacitors.
id 0397
Current in the flux axis (Vector Control)
iq 0398
Current in the torque axis (Vector Control)
Actual Torque 0399
Calculated torque, based on the Iq current.
Path
Same as PNO 393
Same as PNO 393
Same as PNO 393
Parameters::Motor Control::Feedbacks
Parameters::Motor Control::Feedbacks
Same as PNO 393
Default Range
x.xx -1500.00 to 1500.00
x.xx -200.00 to 200.00
x. 0 to 1000
x.x -600.0 to 600.0
x.x -600.0 to 600.0
x.x -600.0 to 600.0
Units Writable
NEVER
rev/s
NEVER
%
NEVER
V
NEVER
%
NEVER
%
% NEVER
AC30 series Variable Speed Drive