Parker AC30 Serie Manual Del Producto página 496

D-204
Parameter Reference
Parameter Name No.
Active 33 - 64 0513
A 32-bit word that indicates trip sources that are active. Bit 0 of this word corresponds to trip 33, up to bit 31 of this word which
corresponds to trip 64.
Warnings 1 - 32 0829
A 32-bit word that indicates trip sources that are close to a fault condition. For example, the heat sink fault monitoring firmware reports
a HEATSINK OVERTEMP warning when the heat sink temperature gets close to the heat sink fault level.
The Warnings value is not affected by the trip enable mask, "Enabled 1-32".
Refer to Chapter 10 "Trips and Fault Finding" for details of the value corresponding to each trip.
Path
Monitor::Trips
:Trips Status
Parameters::Trips:
Monitor::Trips
Parameters::Trips::Trips Status
Default Range
0:01 OVER VOLTAGE
1:02 UNDER VOLTAGE
2:03 OVER CURRENT
3:04 STACK FAULT
4:05 STACK OVER CURRENT
5:06 CURRENT LIMIT
6:07 MOTOR STALL
7:08 INVERSE TIME
8:09 MOTOR I2T
9:10 LOW SPEED I
10:11 HEATSINK OVERTEMP
11:12 INTERNAL OVERTEMP
12:13 MOTOR OVERTEMP
13:14 EXTERNAL TRIP
14:15 BRAKE SHORT CCT
15:16 BRAKE RESISTOR
16:17 BRAKE SWITCH
17:18 LOCAL CONTROL
18:19 COMMS BREAK
19:20 LINE CONTACTOR
20:21 PHASE FAIL
21:22 VDC RIPPLE
22:23 BASE MODBUS BREAK
23:24 24 V OVERLOAD
24:25 PMAC SPEED ERROR
25:26 OVERSPEED
26:27 STO ACTIVE
27:28 FEEDBACK MISSING
28:29 INTERNAL FAN FAIL
29:30 CURRENT SENSOR
30:31 POWER LOSS STOP
31:32 SPEED SENSOR
Units Writable
NEVER
NEVER
AC30 series Variable Speed Drive