Teach-In Function For A New Actuator - SICK T4000 Instrucciones De Operación

Operating Instructions
T4000
Note
8009704/US09/2010-12-20
Commissioning and operation
4. The operating voltage applied to the evaluation
unit must then be disconnected for a minimum
of 10 seconds to activate the actuator code
taught in the evaluation unit.

6.1.2 Teach-in function for a new actuator

1. Apply the operating voltage to the evaluation
unit.
2. Move the new actuator towards the sensor
(note distance < S
commences; green LED blinks (approx. 1 Hz)
3. Teach-in operation complete (after 60 sec-
onds) – green LED goes out, new code is saved
and old code is deactivated.
4. The operating voltage on the evaluation unit
must then be disconnected for a minimum of
10 seconds to activate the actuator code
taught in the evaluation unit.
It is not possible to teach the same actuator on
the same evaluation unit more than once.
The number of valid Teach-in operations on one
evaluation unit is limited to a maximum of 8.
The evaluation unit can be operated only with the
last actuator taught.
A Teach-in operation is invalid if:
– the Teach-in operation is aborted before the
green LED goes out,
– The supply voltage has been disconnected dur-
ing the Teach-in operation.
© SICK AG • Industrial Safety Systems • Germany • Subject to change without notice
) – Teach-in operation.
ao
6
Chapter
161