Commissioning
6.5
Commissioning the unit
Important (Notice)
For additional information about operation and menu navigation, refer to the operating
instruction for the device.
6.5.1
Downloading the system data
1. Switching on supply power. After switching on the supply power, the following messages are
displayed in the LCD window:
System Startup
LOADING SYSTEM DATA
2. Download the system data as follows:
For a completely new system or initial startup
•
The calibration data of the flowmeter sensor and the transmitter settings are loaded from the
SensorMemory
After replacing the complete transmitter or transmitter electronic unit
•
Select with
transmitter settings are loaded from the SensorMemory
After replacing the sensor
•
Select with
settings are loaded from the SensorMemory
are stored in the SensorMemory
configured flow range.
3. The flowmeter is ready for operation and will operate with factory settings or settings
requested by the customer. To change the factory settings, refer to the "Parameterization"
section in the operating instructions.
1) The SensorMemory is a data memory integrated in the flowmeter sensor.
Important (Notice)
System data must only be loaded during initial startup. If the supply power is later switched off,
the transmitter automatically loads the data once again the next time it is switched on.
A selection as described below (1-3) is not required.
44 - EN
System Startup
VERIFYING SYSTEM DATA
1)
into the transmitter.
"Transmitter". The calibration data of the flowmeter sensor and the
"Sensor". The calibration data of the flowmeter sensor and the transmitter
1)
. If the new sensor is a different size, check the currently
FEX300, FEX500
INSTALLATION CHANGED
Identify Changed Item
Transmitter.
1)
into the transmitter.
1)
into the transmitter. The transmitter settings
System Startup
Sensor
CI/FEX300/FEX500-X1