Electrical Connection; Preparing And Routing The Signal And Magnet Coil Cable; Cable With Part Number D173D027U01 - ABB ProcessMaster Instrucciónes De Puesta En Marcha

5

Electrical connection

5.1

Preparing and routing the signal and magnet coil cable

5.1.1

Cable with part number D173D027U01

Prepare both cable ends as shown.
Important (Notice)
Use wire end sleeves.
• Wire end sleeves 0.75 mm
• Wire end sleeves 0.5 mm
The shields may not touch (signal short circuit).
Fig. 24: Flowmeter sensor side, dimensions in mm (inch)
Fig. 25: Transmitter side, dimensions in mm (inch)
L maximum stripped length = 105 (4.10)
1
1 Measurement potential 3, green
2 Signal line E1, violet
3 Shield 1S
4 Shield 2S
5 Signal line, E2, blue
6 Data line, D2, yellow
CI/FEX300/FEX500-X1
2
(AWG 19), for shielding (S1, S2)
2
(AWG 20), for all other wires
L2 = 70 (2.76) 7 Data line, D1, orange
L2 = 60 (2.36) 8 Magnet coil, M2, red
L2 = 60 (2.36) 9 Magnet coil, M1, brown
L2 = 60 (2.36) 10 Groundwire, steel
L2 = 60 (2.36) 11 SE clamp
L2 = 70 (2.76)
FEX300, FEX500
Electrical connection
L2 = 70 (2.76)
L2 = 90 (3.54)
L2 = 90 (3.54)
EN - 25