1- How To Change The Amount Of Rotor Knives - Nogueira NEW PECUS G2 Serie Manual De Instrucciones

4. Preparation

4.1.1- How to change the amount of rotor knives:

The machine leaves the factory ready to
harvest with 12 knives. If you want to harvest
with 3, 4 or 6 knives, you must be aware of
the correct positioning during the removal
of the knives, according to the following
instructions.
The use of PPE (Personal Protective
E q u i p m e n t ) i s m a n d a t o r y d u r i n g
operation, maintenance and adjustment
of the machine. Wear suitable gloves and
eye protection. Take special care when
handling knives and counter knife, these
components have sharp areas that can
cause injury if handled without proper
protection and care.
To change the amount of rotor knives, proceed
as follows:
ATTENTION!
Turn off the tractor and remove
the ignition key before starting the
following procedure.
Remove the bolt (A), lift the platform fairing (B);
1.
Remove the bolts (C);
2.
Open the rotor cover (F);
3.
Remove the bolts (H) that secure the knife to
4.
the rotor (G). Remove the suport and knife.
IMPORTANT!
• Where the knives were removed,
r e p l a c e t h e b o l t s ( D ) t h a t
secure the hub to the disc with:
Hex Bolt M16 X 50 MB 1.5 CL
10.9 RI .
• It is important to note that the knives
must be positioned in front of the
launchers (see the figures on the
next page).
48
CAUTION!
Instructions Manual
A
C
C
F
G
KNIFE
LAUNCHER
D
B