1- Lubrication With Oil - Nogueira NEW PECUS G2 Serie Manual De Instrucciones

6. Maintenance

6.1.1- Lubrication with oil

Only in versions equipped with gearbox and
cardan shaft.
ATTENTION!
Turn off the tractor and remove
the ignition key before starting the
following procedure.
Recommended oil: 150/CLP.
Viscosity: ISO 150.
Specification: DIN 51517/3.
Oil capacity:
(A) PTO Gearbox: 1.7 liter.
(B) Rotor Gearbox: 1.5 liter.
Checking the oil level:
Wipe around the level plug on the gearbox.
Loosen the level plug and check that the oil
reaches the hole in the plug.
If necessary, add lubricating oil until it begins to
seep through the hole in the level plug.
Oil Change:
First exchange: after a week or 50 hours of work,
whichever comes first.
Other changes: every year or 500 hours of work,
whichever occurs first.
Procedure for oil changing:
Place the machine in a flat and level place.
1.
Put an appropriate recipient under the
2.
drain plug so that the dripped oil from the
gearboxes is collected.
Remove the breather plug, the drain plug and
3.
leave the oil drip completely.
Replace the drain plug.
4.
Fill with the recommended oil.
5.
Replace the breather.
6.
RECOMMENDED OILS
PETROBRAS LUBRAX GEAR 150
TEXACO MEROPA 150
AGIP BLASIA 150
SHELL OMALA 150
88
LEVEL
Instructions Manual
BREATHER
A
LEVEL
DRAIN
BREATHER
B
DRAIN