How To Align The Sharpener - Nogueira NEW PECUS G2 Serie Manual De Instrucciones

6. Maintenance

6.1- How to align the sharpener

In order the sharpening be uniform, the face of
the stone must remain parallel to the cut of the
knives. If necessary, align the sharpener with the
knives by doing the following:
ATTENTION!
Turn off the tractor and remove
the ignition key before starting the
following procedure.
Remove the 3 nuts (D) and remove the
1.
sharpener from the machine.
Tighten the 3 adjusting nuts (B) to the end
2.
of the bolt until they rest against the plate.
Snap the sharpener back into the machine
3.
by leaning the sharpening stone against the
knives.
Loosen the 3 adjusting nuts (B), until they
4.
touch the sharpener.
Attach the 3 nuts (A).
5.
Turn the handle (C) counterclockwise and
6.
move the sharpening stone away from the
knives.
Turn on the machine (540 rpm at the tractor
7.
PTO).
Turn the handle until the sharpening stone
8.
touches the knives. Then, remove the
sharpening stone and turn off the machine.
Remove the sharpener and observe the knives
9.
carefully. Make sure the stone is touching all
equally.
If the sharpening is not uniform, look at which
10.
side the stone should be tilted.
Mount the sharpener at the machine and
11.
adjust the sharpening stone using the
adjusting nuts (B).
74
D
B
Instructions Manual
 
 
C
B
B