Siemens SINUMERIK 840Di sl/840D sl Manual De Instrucciones página 172

Lista de los ficheros INI
A.16 MBDDE.INI
; LAST: inserts the newest alarm at the bottom
ORDER=LAST
; the alarm/message line is able to scroll the occurred alarms
; possible values:
; 0 or negative value: no scrolling
; 500 - 32767: interval in ms
RotationCycle=0
; determines if the alarm server should connect to ALARM_S/SQ or not
; possible values:
; 0 Alarm_S/SQ not handled
; 1 Alarm_S/SQ handled (default)
Alarm_S=1
; if Alarm_S/SQ handling is enabled this key determines if Quits
should
; be entered into the alarm-protocol
; possible values:
; 0 Alarm_SQ quits are not entered into the alarm protocol
;(backcompatible)
; 1 Alarm_SQ quits are entered into the alarm protocol (default)
Protocol_Alarm_SQ=1
; If Alarm_S/SQ handling is enabled this key determines if the
; workaround regarding an error in the firmware of the PLC is
; active or not. This workaround corrects the listing of
; Alarm_S/SQ in the diagnosis but causes multiple entries in
; the protocol listing of one alarm event (NEW, NULL, QUIT).
; Using a newer PLC firmware (PLC Besy Stand: S7 PLC_315 2DP
; 2AF03 12.30.03 or higher only neccessary at NCU57x.1) this
; workaround can be set inactive to correct protocol writing.
;
; Attention: Setting the workaround inactive while using an PLC
; firmware elder than 12.30.03 leads to unpredictable results!
;
; possible values:
; 0 Workaround active
; 1 Workaround inactive (default)
Alarm_S_FWA_Inactive=1
; path and file names of the alarm text lists
; The filename fragments must not exceed 6 chars, because it is
extended
; automatically by the message module according to the selected
language.
; The alarm texts in the files specified under UserMMC, UserNCK ...
; overload the corresponding texts of the files defined in MMC, NCK
...
; Therefore the user should modify files according to the needs of
his
; system exclusively in UserMMC, UserNCK ...
; Creating alarm text with any DOS-editor may cause Problems with
special
168
Manual de puesta en servicio, 11/2006, 6FC5397-0DP10-0EA0
HMI-Advanced