Warranty; Software Not Covered By Warranty; Limitation Of Liability - Myray ZEN-X Instrucciones De Uso

The operating symbols indicate:
See paragraph "Use of the sensor" for further information.

6 Warranty

The manufacturer warrants safety, reliability and performance of the equipment.
IMPORTANT INFORMATION !
The manufacturer shall not be held liable for any personal injury or property damage arising from failure to heed the
following clauses.
This warranty is conditional upon the observance of the following prescriptions:
- Heed the conditions given on the warranty certificate found in the box.
- The appliance must be used exclusively in accordance with the instructions contained in this instruction manual.
- The electric installation in the room in which the apparatus is installed must comply to standard IEC 60364-7-710
(Standards regarding electrical installations in medical locations).
- Installation, repairs, settings and in general all the operations for which the equipment covers need to be opened
must be carried out only by technicians authorized by the manufacturer.

6.1 Software not covered by warranty

The Software is supplied in its original condition and the Manufacturer shall not be held liable or warrant any original
defects or defects originating over time and shall not guarantee quality and proper operation of the software. In addi-
tion, the manufacturer shall not honor or provide any warranty regarding conformity of the software to the information
given on-line or in electronic documentation or in any case made available except for the warranty for the CD-ROM if
damaged or unusable.
Any warranty is also excluded for Software integrated in - or otherwise being a part of - other Software applications
developed by third parties. As far as these applications are concerned, the Manufacturer also expressly declares not to
have carried out and not to carry out any inspection activity or other activities to guarantee the software operation.

6.2 Limitation of liability.

In no case shall the Manufacturer or its suppliers be responsible for direct or consequential damages (including dam-
ages for profit loss or lost earnings or savings, interruption of business activities, loss of data or information or other
economic losses) affecting the User or third parties as a consequence of the use or failure to use the Software, also in
the event that the Manufacturer had been warned of the possibility of such damages. The present limitation of liability
is applicable not just to cases of software use not in compliance with the Manufacturer's recommendations but also to
ZEN-X / ZEN-Xi
- OPERATING INSTRUCTION
"Important information" symbol
"Read the instructions manual" symbol
Stand-by position
Work position
Position for taking out the sensor cradle
Home position
The symbol indicating the part can be autoclaved is given on the sensor cradle
EN 33