Zen-X; Zen-Xi - Myray ZEN-X Instrucciones De Uso

A red light indicates a serious fault for which it is not possible to take the x-ray (the self-diagnosis system detected at
start up).
A yellow light indicates a temporary situation (initialization, image transfer) or a fault which the user should be aware
of (e.g.: sensor not connected);
A blue light indicates the system is connected to the Personal Computer but not on;
Consult the sensor status table for a detailed description of the messages.
SENSOR STATUS TABLE
Red Error during execution of self-diagnostic testing
Yellow flashing light
Steady yellow light
Blue (slow flashing Sensor in stand-by
light)
Green Ready: sensor on and ready to receive an image

18 ZEN-X

ZEN-X does not have its own start button. Once connected to a PC, the TWAIN
will initialize the ZEN-X system if iCapture Monitor is running (factory settings).
Initially a yellow light will come on and "WAIT" will appear on a yellow background in the MyRay
dow in ZEN-X.
If the sensor is connected, "WAIT" appears in yellow in window MyRay
"READY" appears in green in window MyRay
At this point, the ZEN-X system is ready to receive an x-ray image.
If the sensor is NOT connected, "SENSOR NOT CONNECTED" appears in red in window MyRay
a few seconds and the light on ZEN-X will become blue (stand-by).
If the ZEN-X system is connected to a PC in which MyRay
modified by the user), it is not possible to acknowledge and initialize. In this case, the light will become blue to signal
the ZEN-X system is in stand-by and x-ray pictures cannot be taken.
Consult the iCapture manual to start MyRay
When MyRay Driver TWAIN
®
to function after a few seconds.

19 ZEN-Xi

As ZEN-Xi is installed on the instrument board as the sixth instrument, it may be to the right or left of the instrument
board depending in the particular case. For this reason, two indicator lights are provided. They are placed so that the
operator can always see at least one of them under regular work conditions.
The sensor cradle can be turned and placed in four distinct positions.
On
Operation is similar to that of the ZEN-X system when in this position.
Once connected to a computer with MyRay
and initialized.
Initially a yellow light will come on and "WAIT" will appear on a yellow background in the MyRay
42 EN
ZEN-X / ZEN-Xi
● Sensor not connected
● iCapture not on
● Setup in progress
● Calibration in progress
Driver TWAIN
®
Driver TWAIN
®
is turned on, the drivers are automatically identified and started and the system is ready
®
Driver TWAIN
®
- OPERATING INSTRUCTION
Driver TWAIN
®
and the light on ZEN-X will become green.
®
Driver TWAIN is NOT on (the factory settings have been
® ®
.
®
started, the required drivers are automatically identified
®
driver is automatically started which
®
Driver TWAIN
®
and after a few seconds
®
Driver TWAIN
®
Driver TWAIN
®
win-
®
after
®
win-
®