Scope Of Delivery; Description And Working Principle; Product Information; Motor Assembly Types - Wilo MMI50V Instrucciones De Instalación Y Funcionamiento

40 110 100 125 194
50 150 135 165 261
65 185 170 210 327
80 225 205 250 394
100 300 270 335 525
125 355 320 395 620
150 450 405 500 785
200 600 540 670 1049 265 325
250 745 675 835 1307 365 445
300 895 805 1000 1565 495 605
*Design with threaded flange at discharge side : M/z = 0 N.m
SUCTION:
No load is allowed on the suction port. It should be used only to connect
strainer or extension pipe.
5.2.7

SCOPE OF DELIVERY

Pump can be delivered as a complete pump set including electrical
motor, flexible coupling, coupling guard and baseplate. It can be also
delivered without one of those parts. A CE integration certificate is then
supplied.
This instructions and operating manual is part of the pump supply and
should be delivered attached to the pump. If not, ask WILO Customer
department to get it.
ATEX pumps may be delivered with specific instrumentation. Refer
to pump technical datasheet or to acknowledgment of order to know
exhaustive scope of supply.
6

DESCRIPTION AND WORKING PRINCIPLE

6.1 PRODUCT INFORMATION

Norma V pumps are pit pumps with dry motor. The centrifuge hydraulic
has vertical inlet and radial outlet. A discharge pipe is integrated to allow
hydraulic connection above mating plate.
Integrated support clamp can be used for direct installation (assembly
type CS). Pumps can be fitted with a rectangular mating plate fully
adaptable to customer needs (ISO or ANSI, special shape, ...)
Shaft bearings can be lubricated by the pumped fluid or another fluid
available on site.
Different assembly variants exist for drives. Motors frames are V1 or V18
according to IEC standard.
6.1.1

MOTOR ASSEMBLY TYPES :

6.1.1.1 MOTOR ASSEMBLY TYPE CS :
A clamp is fastened on pump column and allows easy adjustment of
pump length under mating plate. The drive is directly fastened on upper
column flange. Maximum installed power is 9KW for this design. A rigid
coupling keyed onto pump and motor shafts is used for power
transmission. Size "O" smaller than 1300mm.
105 130 90 190
115 140 100 207
120 150 110 221
130 160 115 236
145 175 125 259
190 210 150 320
205 250 175 368
230 478
315 656
430 892
6.1.1.2 MOTOR ASSEMBLY TYPE EM :
A cast iron lantern is installed between column upper flange and drive to
allow bigger drives to be installed (up to 18.5KW). This pump
arrangement does not allow axial adjustment of the column. A rigid
coupling keyed onto pump and motor shafts is used for power
transmission. Size "O" smaller than 1300mm.
6.1.1.3 MOTOR ASSEMBLY TYPE TM :
A bearing bracket fitted with two ball bearings is used to support axial
load. This arrangement is available for pumps length above 1920 mm
under mating flange. Ball bearings are grease lubricated. Power is
transmitted through a semi elastic coupling to the pump shaft.
6.1.1.4 MOTOR ASSEMBLY TYPE TH AND MOTOR FRAME
V1 :
A bearing bracket fitted with one over-sized ball bearing is used to
support axial load. This arrangement is available for pumps length above
1920 mm under mating flange. The ball bearing is lifetime lubricated.
Power is transmitted through a rigid coupling to the pump shaft (keyed).
ENGLISH
11