Civco Verza Manual De Instrucciones página 6

Ocultar thumbs Ver también para Verza:
Tabla de contenido

Publicidad

English
Ensure no air bubbles are present prior to use. Air left between cover and transducer lens may cause poor
n
image quality.
If the product malfunctions during use or is no longer able to achieve its intended use, stop using the product
n
and call CIVCO.
Report serious incidents related to the product to CIVCO and the competent authority in your Member State
n
or appropriate regulatory authorities.
NOTE: Product is not made with natural rubber latex.
NEEDLE PATH VERIFICATION
Before using component for first time, perform needle path verification to verify system and Verza guide
n
relationships, as described in ultrasound system user guide.
Before each use, verify guidance system angles  (5) correspond with system software.
n
NOTE: Use appropriate needle length to reach target area. Verza guide channel measures 3.4cm (1.34in).
ASSEMBLING TRACKING SYSTEM
1. With latch open, align bracket with locating features on transducer.
2. Close latch around transducer and click to secure. Ensure bracket is securely attached.
3. Place general purpose sensor onto sensor mount.
4. Press general purpose sensor toward bracket and click to secure.
WARNING
Ensure general purpose sensor is securely attached. Failure to do so could result in inaccuracy.
n
USING GUIDANCE SYSTEM
1. Place an appropriate amount of gel inside cover and/or on transducer face. Poor imaging may result if no gel is
used.
2. Insert transducer into cover making sure to use proper sterile technique. Pull cover tightly over transducer face to
remove wrinkles and air bubbles, taking care to avoid puncturing cover.
3. Secure cover with enclosed bands.
4. Inspect cover to ensure there are no holes or tears.
with Verza™ Guidance System
4
Tracking Bracket

Publicidad

Tabla de contenido
loading

Tabla de contenido