Transport - AL-KO SOLO 442 Manual De Instrucciones

Transport

Malfunction
Motor starts, but the motor
output is low.
Motor not running smoothly
and motor speed not increas-
ing when the throttle is ap-
plied.
Motor exhaust smoking heavi-
ly, appears blue.
Motor starts abnormally and
vibrates heavily.
10 TRANSPORT
Transporting the appliance between two
working areas
■
Switch off the motor.
■
Hold the appliance by the handles.
■
Avoid obstructing anyone with the vacuum or
blow tubes.
■
Never bump anything with the vacuum or
blow tubes.
2500043_d
Cause
Air filter is dirty or filter sponge
is worn.
Carburettor settings are not cor-
rect.
Spark plug is dirty, defective or
the electrode spacing is not
right.
Carburettor settings are not cor-
rect.
Collecting sack is full or dirty.
Amount of oil in the petrol/oil
mixture is too high.
Carburettor settings are not cor-
rect.
Appliance/motor parts have be-
come detached and/or are dam-
aged.
Transporting the appliance in a vehicle
■
■
■
■
Remedy
see chapter 8.1 "Cleaning/re-
placing the air filter (20)",
page 35
Contact an authorised service
workshop.
see chapter 8.2 "Maintaining the
spark plug (21)", page 36
Contact an authorised service
workshop.
Empty the collecting sack (see
chapter 7.2 "Working in vacuum
operation (19)", page 34).
Shake out the collecting sack.
Remove any adhering, vacu-
umed material with a hand
brush.
Pour in petrol/oil mixture with
correct mixture ratio.
see chapter 12 "Technical data",
page 40
see chapter 5.2 "Making and
pouring in the petrol/oil mixture",
page 32
Contact an authorised service
workshop.
1. Stop the motor.
2. Inspect the appliance for
damage.
3. Check the spark plug (see
chapter 8.2 "Maintaining the
spark plug (21)", page 36).
4. Contact an authorised ser-
vice workshop.
Switch off the motor.
Remove the vacuum and blow tubes as well
as the exhaust air manifold and the collecting
sack from the appliance.
Put the appliance into the vehicle and fix in
place. This avoids it tipping over when driving
and the petrol/oil mixture running out.
Place all accessory parts (where possible
from the size) in the collecting sack and close
it. This avoids uncontrolled movement in the
vehicle when driving.
39