Kärcher B 260 RI Combo Manual Del Usuario página 19

Symbols on the charger
DANGER
Risk of fire
If plugged into an unsuitable socket or in the event of
poor electrical connection between the plug and the
socket, the charger plug and the socket used may get
very hot.
Before plugging in the mains plug, make sure that the
socket is approved for a current of 16 A and that it is in
a technically sound condition.
Make sure that the mains plug is clean and in a good
condition.
CAUTION
Do not operate the device together with other devices
on an extension cable with multiple power sockets.
Description of the device
Device overview, front
Illustration B
Steering wheel
1
Fresh water tank automatic filling system
2
pre-sweeping unit hood***
3
Side brushes*
4
Driving motor
5
Squeegee blade holder
6
Squeegee blade
7
Suction bar
8
* Optional
*** Combo variant only
Device overview, rear
Illustration A
Overhead guard*
1
Flashing beacon*
2
Blue spotlight rear/ front*
3
Suction lance for DOSE detergent dosing unit*
4
Waste water tank cap
5
Fresh water drain hose
6
Waste water drain hose
7
Manual tank cleaning - spray gun
8
Suction hose
9
Suction beam ram protection*
10
Waste water tank inspection opening
11
Waste container***
12
Fresh water lid
13
Control panel
14
* Optional
*** Combo variant only
Device overview, seat
Illustration C
Detergent tray for DOSE detergent dosing unit*
1
Seat
2
Steering wheel knob
3
Weight adjustment lever
4
Seat length adjustment lever
5
* Optional
Device overview, waste water tank
Illustration D
Waste water tank support
1
Float
2
Waste water impact protection
3
Waste water tank cap
4
Coarse dirt basket
5
Turbine pre-filter
6
Waste water tank
7
Device overview, pedals
Illustration AP
Coarse dirt flap pedal
1
Brake pedal
2
Accelerator pedal
3
Device overview, pre-sweeping unit
Illustration E
Filter housing cover
1
pre-sweeping unit hood***
2
Side brushes***
3
Filter housing
4
Sweep container
5
*** Combo variant only
Type plate
Illustration AJ
Type plate
1
Control panel
Illustration F
Program switch
1
Display
2
QR code for the how-to video
3
Info button for menu navigation in the display
4
Driving direction switch
5
2-stage horn
6
Cleaning solution ON/OFF
7
Side brush/side scrubbing deck ON/OFF (side
8
brush option with Combo variant)
Intelligent key
9
Maximum permissible gradient
10
Safety switch
11
Program switch
Illustration G
0
1
Device is switched off.
Transport journey
2
Drive to the operating location.
Eco program
3
Clean the floor wet (with a reduced water quantity
and a reduced brush speed) and vacuum up waste
water (with reduced suction power).
Scour and vacuum
4
Clean the floor wet and vacuum up waste water.
Increased brush contact pressure
5
Clean the floor wet (with increased brush contact
pressure and increased water quantity) and vacu-
um up the waste water.
Scouring / pre-cleaning without vacuuming
6
Clean the floor wet and let the detergent act.
Vacuuming
7
Vacuum up the dirty liquid.
English
Polishing
8
Polish the floor at a high brush speed without apply-
ing liquid.
Symbols on the device
Drain for fresh water
Drain for waste water
Fresh water
Fresh water tank automatic filling system
Removing the coarse dirt basket
Lashing point
* Optional
Pictograms on the display
Battery full
Battery empty
Brake activated
Preliminary sweep work activated
Water off
Detergent activated
Detergent empty
Fresh water 100%
Fresh water 0%
Installation
Batteries
Recommended batteries, chargers
Order no.
Battery set 2.815-108.0
Charger 4.035-191.0
Volume (m3)* 71.78
Airflow (m3/h)** 27.71
* Minimum volume of the battery charging room
** Minimum airflow between battery charging room and
environment
Batteries and chargers are available from specialist
shops.
Maximum battery dimensions
Length Width
842 627 mm
The following must be observed when fitting the wet bat-
teries:
● The maximum battery dimensions must be ob-
served.
Height
537 mm
19