Descargar Imprimir esta página

Wilo T72 Instrucciones De Instalación Y Funcionamiento página 198

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1391
en
Non-immersed operation allowed
4.4
Operation with frequency con-
verter
4.5
Operation in an explosive atmo-
sphere
ATEX approval
FM approval
CSA-Ex approval
ATEX approval
FM approval
CSA-Ex approval
198
Product description
Yes
No
Yes
Observe the following points during non-immersed operation:
▪ Operating mode "non-immersed" indicated
The motor emerging in "non-immersed" operating mode is permissible.
▪ Operating mode: "non-immersed" not indicated
If the motor is fitted with a temperature controller (2-circuit temperature monitoring),
emergence of the motor is permitted. Automatic reactivation can be initiated after the
motor has cooled down using the low temperature. The unit is forced to deactivate with
reactivation lock once the high-temperature has been reached. CAUTION! To protect
the motor winding from overheating, the motor must be equipped with a temper-
ature controller! If only one temperature limiter is installed, the motor must not
emerge during operation.
▪ Max. fluid and ambient temperature: The maximum ambient temperature corresponds
to the maximum fluid temperature shown on the rating plate.
CAUTION! The following applies to motor T 12: During non-immersed operation, the
fluid temperature and ambient temperature must not exceed 30 °C!
Operation on the frequency converter is permitted. Refer to the appendix for the relev-
ant requirements!
Overview of standard motors
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
Key
− = not available/possible, o = optional, • = as standard
Overview of IE3 motors (derived from IEC 60034)
o
o
o
o
Key
− = not available/possible, o = optional, • = as standard
For use in explosive atmospheres, the pump must be marked as follows on the rating
plate:
Yes
No
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
Yes
No
o
o
o
o
o
o
o
o
o
WILO SE 2019-01

Publicidad

loading