Sirona ORTHOPHOS XG 5 Instrucciones De Montaje página 86

7 Mechanical conversion
7.4 Replacing the ring motor
A
B
24
Converting instructions for the "ORTHOPHOS XG 5 to XG 3D upgrade kit" ORTHOPHOS XG 5
7.4
Replacing the ring motor
Replacing the ring motor
X813
1. Detach the ring motor cable from the cable harness and pull it off
connector X813 on board DX1.
2. Loosen the four screws (A) on the ring motor and remove the motor
including the screws and the serrated washers (B).
3. Insert the new motor into the ring.
Tip: While inserting the motor, turn it back and forth slightly until the
pinion engages in the ring gear.
4. Use the screws (A) and serrated washers (B) to screw the new motor
onto the ring motor support securely.
5. Run the ring motor cable along its original path and plug it back into
connector X813 on board DX1 (see the ORTHOPHOS XG 3D/Ceph
Service Manual).
IMPORTANT: Don't forget to reattach all cable ties and clamps.
Sirona Dental Systems GmbH
63 52 970 D3352
D3352.092.08.05.02 07.2012