Sirona ORTHOPHOS XG 5 Instrucciones De Montaje página 96

7 Mechanical conversion
7.11 Laying fiber-optic cable L15
Laying fiber-optic cable L15 (DX6 side)
on the ring
34
Converting instructions for the "ORTHOPHOS XG 5 to XG 3D upgrade kit" ORTHOPHOS XG 5
3. Attach a radius limiter (included in the upgrade kit) level with the cable
feed-through in the arm (A) and in front of the plug connection to
board DX1 (B) on fiber-optic cable L15.
➢ Route fiber-optic cable L15 (DX6 side) parallel to cables L20 and L21
along the ring in the sliding plate brackets to the tube assembly.
IMPORTANT: The cables should be laid in the brackets in the
following order: from below: L20, L21, L15, L21.
The thinner fiber-optic cable L15 should be second from the top so
that it cannot slip out of the sliding plate brackets.
Sirona Dental Systems GmbH
63 52 970 D3352
D3352.092.08.05.02 07.2012