Kärcher B 300 RI BP Manual Del Usuario página 57

6.2.5 Begin wet cleaning
1 Brush contact pressure rotary switch
2 Scrubbing deck water dosage
3 Brush head water dosage
6.2.5.1 Adjusting the brush contact pressure
The brush contact pressure rotary switch has three set-
tings:
ECO

MEDIUM

6.2.6 End wet cleaning process
Stop the machine.

Switch off cleaning mode function switch (centre posi-

tion).
Note
The brushes lift up.
Switch off hydraulics.

The brushes stand still.
After cleaning

Empty the dirt water reservoir.

Empty waste container.

(see Chapter "Sweeping | Emptying the waste contain-
er")
Clean the device, waste water tank, fresh water tank,

suction bar and spray nozzles.
(see Chapter "Cleaning").
ATTENTION
Risk of accident, risk of injury!
Keep unauthorised persons away from the cleaning ar-

ea.
Set up a corresponding warning sign.

Close the flap of waste container

Operate the control lever and switch on the hydraulics.

Set the cleaning mode function switch to wet cleaning.

Note
The suction bar is lowered and the suction turbine
starts.
Select the water dosage for the scrubbing deck and

brushes.
If necessary, adjust the brush contact pressure, see

Chapter "Adjust brush contact pressure".
Select the performance class (ECO or normal mode).

Release parking brake.

Start with the wet cleaning process.

Note
The dirt that is picked up is collected in the waste water
tank and, if necessary, in the waste container.
HART

Increase brush contact pressure - turn clockwise

Decrease brush contact pressure - turn anticlockwise

19
-
EN 57