Kärcher B 300 RI BP Manual Del Usuario página 58

6.2.7 Emptying the waste Water tank
6.2.8 Emptying the Fresh Water Tank
58
WARNING
Risk of personal injury or damage!
Always apply and secure the safety support with the tilt-

ing device raised.
CAUTION
Please observe the local provisions regarding the waste-
water treatment.
Empty the waste water tank only via a suitable collec-

tion unit.
ATTENTION
If the waste water tank is full, the suction turbine switches
off and the indicator lamp "Waste water tank full" lights up.
1 Safety support
2 waste water tank
3 Dirt water discharge hose
4 Cleaning flap
Depending on the type of dirt, the cleaning flap must be
opened regularly and the tank flushed.
Empty waste container.

(see Chapter "Sweeping | Emptying the waste contain-
er")
Afterwards, secure the waste container with the safety

support.
The waste water tank drain hose is located on the right-
hand side of the device.
1 Closing head
2 Bracket
3 Dosing equipment
4 Dirt water discharge hose
5 Drain hose retainer
Remove the drain hose from the holder.

Unscrew the lock from the drain hose.

The water flow can be reduced by squeezing the dos-

ing unit.
Hook the drain hose in the support after emptying and

then press it into the retainer.
The fresh water tank drain hose is located on the left-hand
side of the device.
1 Closing head
2 Bracket
3 Dosing equipment
4 Drain hose retainer
5 Drainage hose for fresh water
Remove the drain hose from the holder.

Unscrew the lock from the drain hose.

The water flow can be reduced by squeezing the dos-

ing unit.
Hook the drain hose in the support after emptying and

then press it into the retainer.
20
-
EN