OIL CHANGE REMINDER
SYSTEM
This system informs the operator of the time for
replacing engine oil on the basis of the mainte-
nance schedule.
The system is designed to register the total
operating hours of the outboard motor and
function its operation when the preprogrammed
hours have reached.
(Refer to the INSPECTION AND MAINTE-
NANCE section and the last page.)
SYSTEM ACTIVATION
When the total operating hours have reached
the preprogrammed hours, the OIL lamp will
flash. If the engine is not running, the buzzer
will begin a series of double beeps additionally.
This indication will repeat until you cancel the
system activation.
CANCELLATION
1. Turn the ignition key to the "ON" position.
2. Pull out the emergency stop switch plate 1.
3. Pull up the emergency stop switch knob 2
three times in 10 seconds. A short beep will
be heard if the cancellation is successfully
finished.
4. Turn the ignition key to the "OFF" position.
5. Set the plate 1 in the original position.
NOTE:
• Canceling of the system activation is possible
regardless of whether or not the engine oil
has been replaced. Once the system has
operated, however, Suzuki strongly recom-
mends that the engine oil be replaced before
canceling the system activation.
• Even if the engine oil has been replaced with
the system not operating, it is still necessary
to perform the cancellation.
27