Suzuki DF40A Manual Del Propietário página 45

Remote control model
"UP" switch
TROLL MODE
"DN" switch
Troll mode switch
NOTE:
The troll mode system will not operate if the
switch is depressed when the handle/shift lever
is in the neutral position.
Adjusting trolling speed:
• When pressing the "UP" switch, one short
beep sounds
increases by 50 r/min.
• When pressing the "DN" switch, one short
beep sounds
decreases by 50 r/min.
NOTE:
• When pressing the "DN" switch at the lower
limit of trolling speed, the engine speed will
not change and three long beeps will sound.
• When pressing the "UP" switch at the upper
limit of trolling speed, the engine speed will
not change and three long beeps will sound.
• Shift operation and throttle control remain
operational, even in troll mode.
Cancelling the troll mode:
The troll mode can be cancelled by shifting the
handle/shift lever to the neutral position, or by
increasing the engine speed to 3000 r/min or
more. In both cases, two short beeps sound
when cancelling the troll mode.
42
Tiller handle model
and the engine
and the engine
OPERATION IN SHALLOW WATER
When operating your boat in shallow water, it
may be necessary to tilt the motor higher than
the normal trim angle. When you tilt the motor
beyond the normal trim angle, however, you
should only operate the boat at slow speeds.
After returning to deep water, be sure to lower
the motor to the normal trim angle.
DF40A (QH) MODEL
To tilt the motor higher than the normal trim
angle:
1. Stop the engine.
2. Move the release lever 1 to the release
position.
speed
speed
3. Slowly tilt the motor up to appropriate trim
angle.
4. Move the release lever 1 to the lock posi-
tion.
To lower motor back down:
1. Shift into "NEUTRAL".
2. Move the release lever 1 to the release
position.
3. Push the handle on the back of motor cover
and slowly let the motor down.
4. Move the release lever 1 to the lock posi-
tion.
RELEASE
LOCK