Publicidad
Idiomas disponibles
Idiomas disponibles
EN
After set up machine, turn on the power source, and then proceed parameter installation.
1. Press the PROCESS button to choose welding method.
+ MIG/MAG - Metal Inert/Active Gas use for gas shielded solid/flux core wire.
+ SS-FCAW - MIG method use for no gas shielded flux core wire.
2. Hold the JOG button to check the wire after set up the loading wire feeder.
3. Hold the PURGE, to check out the gas after set up.
4. Press the SYN/MAN WIRE SIZE button, select the COMBINE-SYN adjustment mode for each
type of welding wire size 0.8, 0.9, 1.0 mm. The corresponding LED for each selected adjustment
mode will light up.
5. Press and release ADJUST button to choose the parameter SPEED need to be adjust. After
choosing, both of the LED SPEED - M/MIN, and LED V - VOLTAGE are turn on.
Turn the Adjust button to increase/decrease the value of Welding voltage and wire speed.
6. Screen of meter will display the value of welding voltage and wire speed, and then, the LED
below screen of meter will turn on respectively.
In the welding process, if you want to improve the welding voltage to suit with the wire speed.
Press and release ADJUST button until just have the LED of VOL turn on, that mean is the
parameter VOL is chosen to adjust by + 1V.
Publicidad
