STAMOS TRON 200 RV Manual De Instrucciones página 92

• MMA - Manual metal arc method.
LIFT - ARC TIG - Starting arc by Lift - Arc start method, Touch tungsten electrode to workpiece
•
at weld start point, enable output and shielding gas with torch trigger, foot control, or hand
control. Hold electrode to workpiece for 1-2 seconds, and slowly lift electrode. Arc is formed
when electrode is lifted.
• MIG/MAG - Metal Inert/Active Gas use for gas shielded solid/flux core wire.
• SS-FCAW - MIG method use for no gas shielded flux core wire.
5. ADJUST - Press and release the button to choose the welding parameter that need to be
adjusted and turn it to increase or decrease that parameter. The LED of each parameter will turn
on after chosen.
• V: Welding Voltage
M/MIN: Wire speed (M/MIN)
•
• A: Welding Current
: Inductance
•
- Turn the button to increase/degrease each parameter chosen before. The value will be display
on the screen of meter (6) and (7) respectively.
6. Welding Voltage Meter Showing the value of welding voltage setting before and while welding.
7. Meter indicate welding current, wire speed and inductance Showing the value of welding
current, wire speed and inductance, respectively the Led of each value is chosen that will turn on.
8. V - VOLTAGE - The LED indicate Voltage parameter - When this LED turn on which is the
Voltage value is being chosen to adjust the value.
9. OUTPUT - ON - The LED indicate welding status.
10. O.T - The LED indicate overheat status: When overheat occurs, the Over current LED will turn
on and terminates output current. It turns off when the machine has cooled down enough thus
welding can be resumed.
11. A - CURRENT - The LED indicate welding current.
12. INDUCTANCE - The LED indicate inductance.
13. M/MIN - The LED indicate wire speed.
Notice: When the LED correspond with each parameter turn on, that parameter is being chosen
to adjust, both of meters (6) and (7) display the respective value at the same time.
5.2. Install the parameter for MIG method
5.2.1. SYNERGY (SYN) function
Notice: Need to set up the machine follow the right instruction at 3.2.2 or 3.2.3 in Owner's
manual. Set up the machine for each type of electrode wire.
EN