Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1. Insert Dinse connector of TIG Torch fully into negative output terminal. Rotate connector
clockwise to lock in position.
2. Connector part (Additional part if required).
3. Connect the gas line of TIG torch to the output gas hose.
4. Connecting Mass clamp to negative (-) welding output terminal and clamp to the workpiece as
close as to the welding areas.
5. Connect power plug to 220 VAC, Single-Phase.
6. Connect gas hose to gas cylinder.
7. Earth stub.
4. Set up and operation
Publicidad
