Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Press and release ADJUST button to choose Arcforce function, in the screen meter (3) will display
A-F (ARC FORCE) and the LED A - Welding current will turn on. Turn it to adjust the percentage of
current compensates to initial current.
5.4.
Install the parameter for TIG - LIFT - ARC TIG method
Notice: Need to set up the machine follow the right instruction at 3.2.4 in Owner's manual. Set
up the machine for LIFT- ARC TIG method.
After set up machine, turn on the power source, and then proceed parameter installation.
1. Press the PROCESS button to choose MMA welding method.
2. Press and release ADJUST button to choose the WELDING CURRENT, the LED A - CURRENT will
turn on. And then, turn it to increase or decrease to suit with electrode size to be used.
3. Welding current and welding voltage will be displayed on the screens meter (3) and (4)
respectively.
Automatically turn ON/OFF protective gas valve and welding current in TIG - LIFT TIG function:
Welding current will occur and protective gas valve will turned ON when touching Tungsten
electrode (connecting to negative (-) output terminal) to surface of the workpiece (connecting to
positive (+) output terminal), the arc will be created after lift the tungsten slowly.
Lifting Tungsten electrode far away from the workpiece to stop welding, the arc stop, the gas
valve will be turned OFF.
6. Press hand hold PURGE button to turn ON/OFF the protective gas valve.
Publicidad
