Publicidad
Idiomas disponibles
Idiomas disponibles
Wire size: 0.8mm
Polarity: DCEP (Electrode connect to
Positive output terminal)
Protective gas: 80% Argon + 20%
CO2
Gasflow: 10-15 LPM
Gas Shieled Solid Wire - Stainless
steel - E308L
Wire size: 0.8mm
Polarity: DCEP (Electrode connect to
Positive output
terminal)
Protective gas: 80% Argon + 20%
CO2
Gasflow: 10-15 LPM
6. Daily check
To make best use of the machine, daily checking is very important. During the daily checking,
please check in the order of gun, wire-feeding vehicle, the gas hole, and so on. Remove the dust
or replace some part if necessary. To maintain the purity of the machine, please use original
welding part
6.1.
Power supply
Trouble
No weld output; wire does
not feed, fan does not run.
Power Indicator light is off
No weld output; wire does
not feed, fan motor
continues to run
No weld output, wire feeds Connect work clamp to get good metal to metal contact.
Low weld output
Electrode wire feeding stops
during welding.
EN
Thickness > 6mm,
bevel edge will be
required to ensure
good weld.
1 - 5 mm
Thickness > 6mm,
bevel edge will be
required to ensure
good weld.
Place Power switch in the On position.
Be sure power cord is plugged in and that receptacle is receiving input
power.
Check and replace line fuse(s), if necessary.
Ensure the gun trigger switch is depressed and held.
Check if Over Temperature Light is On. Light goes on and weld
output/wire feeding stops when unit has overheated. To resume
welding, allow fan to cool unit until light goes off .
Disassemble gun handle and check trigger switch lead connections,
tighten or reconnect any loose connections.
Check cable connection at work clamp and tighten hardware if
necessary.
Replace contact tip.
Connect unit to proper input voltage.
Place voltage switch in desired position.
Check cable connection at work clamp and tighten hardware if
necessary
Ensure wire spool is not out of welding wire.
Adjust drive roll pressure.
Check if Over Temperature Light is On. Light goes on and weld
output/wire feeding stops when unit has overheated. To resume
welding, allow fan to cool unit until light goes off.
4
17.5-18.5
5
18.5-19.5
6
19.5-20.5
7
20-21
7
20.5-21.5
9
21.5-22.5
10
22-23
11
22.5 - 23
5
19 - 20
6
19.5 - 20.5
7
20 21
8
21 - 22
9
22 23
10
23 24
Remedy
80-90
100 -110
110 120
120 130
130 140
140 150
150 160
160 170
100 - 110
110 - 120
120 - 130
130 - 140
140 150
150 - 160
Publicidad
