Retrieving Fault Codes From Mcu Systems - Innova 3145 Manual Del Usuario

Retrieving Codes

RETRIEVING FAULT CODES FROM MCU SYSTEMS

TEST
CODE CONDITION
656 C
659 R
662 O
667 C, O
668 C, O
675 O, R
675 C
998 R
NO CODES
* Test condition not available
RETRIEVING FAULT CODES FROM MCU SYSTEMS
Preliminary Procedures
The following "Preliminary Procedures" MUST be
performed before the actual KOEO and/or KOER Self
Tests are performed.
• Always observe safety precautions before and during
testing process.
• Fix any known mechanical problem before this test.
• A voltmeter is required to perform this test.
1. Idle engine until it reaches normal operating temperature.
While engine is running, use a voltmeter to check voltages
2.
between the choke cap and engine ground. For battery
powered choke, voltage should be approximately 12 volts.
For alternator powered choke, voltage should be
approximately 7.5 volts.
3. Turn ignition off.
4. If your vehicle has one or more of the following
configurations perform the Set-Up Procedures as
described below:
65
FAULT CODE DEFINITION
Converter Clutch Control (CCC) continuous
slip error
High vehicle speed in park indication
Shift solenoid 2 circuit
Transmission range sensor circuit below
maximum voltage
Transmission range sensor circuit above
maximum voltage
Transmission range sensor circuit voltage
out of range
Cluster center control circuit failed
dynamic response test
Operating in failure mode
Unable to initiate Self-Test or unable to
output Self-Test codes
4
Chapter 4