Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
[b] HOSE CONNECTIONS
To prevent the risk of gas leaks and hose explosion, do not use any hoses other than specified by the beer company.
Cut the hose end to have a vertical cutting plane and insert it securely into the quick hose joint to ensure a leak-free joint.
Do not reconnect the hoses without cutting them about 20 mm.
Cut the hoses with a specialized tool such as hose cutter. Do not use scissors, or the hoses may be crushed to cause leaks.
CO2 Gas Hose
1) Cut the CO2 gas hose to have a vertical cutting plane and a hose length not
more than 1.4 m.
2) Insert the CO2 gas hose securely into the quick gas hose joint on the keg
coupler and regulator. Pull the hose hard to check for tightness.
Quick Gas Hose Joint
1) To connect the CO2 gas hose, push it all
the way in.
2) To disconnect the CO2 gas hose, push
and hold part (1) with fingers and pull out
the hose (2).
Beer Hose
1) Attach the quick beer hose joint specified by the beer company to the beer
hose adapter.
2) Cut the beer hose to have a vertical cutting plane and a hose length not more
than 2.1 m.
3) Insert the beer hose securely into the keg coupler and quick beer hose joint.
Pull the hose hard to check for tightness.
Note: It depends on the beer company how to connect and
disconnect the beer hose to and from the quick beer
hose joint.
[c] CHECKS AFTER CONNECTIONS
1) Wash the cleaning tank thoroughly and fill it with tap water.
Note: If the cleaning tank is not clean, the beer circuit will be contaminated.
2) Turn the keg coupler clockwise to attach it to the cleaning tank.
Note: Wash the joint between the keg coupler and cleaning tank if it is not clean.
3) Lift up and remove the platform.
4) Place a bucket on the drain pan to receive cleaning water.
WARNING
NOTICE
Quick Gas Hose Joint
Push
(1)
Beer Hose
10
Rotary Type
Vertical Type
Keg Coupler
Gas Hose
(2)
Beer Hose Adapter
Quick Beer Hose Joint
Rotary Type
Rotary Type
Regulator
Vertical Type
Keg Coupler
Vertical Type
Publicidad
