Publicidad
Idiomas disponibles
Idiomas disponibles
Handle the platform with care. If it is dropped and damaged, proper mug size detection may not be available.
If the platform is damaged, contact your dealer/supplier.
5. CLEANING BEER CIRCUIT WITH SPONGE (WEEKLY)
To flush the beer circuit, use the cleaning tank specified by the beer company. Follow the instructions provided with the cleaning
tank.
1) Follow the steps of "2. BEER CIRCUIT (DAILY)".
2) Lift up the operation panel unit slowly until it locks into place.
3) Turn the union nut clockwise to remove the beer tap.
Handle the beer tap with care and do not drop it.
4) Loosen the cap nut to disassemble the beer tap. Fit the valve shaft in the
opposite direction and tighten the cap nut.
Attach the valve shaft in the opposite direction to prevent the cleaning sponge
from clogging the beer tap.
Handle the valve shaft with care. If it is deformed or damaged, beer may leak.
Handle the beer tap lever with care and do not drop it.
5) Attach the beer tap on the unit by turning the union nut counterclockwise.
6) Remove the accessory drain pan and grille. See "3. DRAIN PAN AND GRILLE (DAILY)".
7) Place a bucket under the beer tap to receive cleaning water.
8) Turn the keg coupler counterclockwise to remove it from the beer keg.
9) Remove the quick beer hose joint from the keg coupler, and put only one cleaning sponge (accessory) into the joint.
Use of more than one cleaning sponge or a non-accessory sponge can cause
clogging of the beer circuit. In such case, contact your dealer/supplier.
10) Attach the quick beer hose joint to the keg coupler.
11) Wash the cleaning tank thoroughly and fill it with tap water.
Note: If the cleaning tank is not clean, the beer circuit will be contaminated.
NOTICE
NOTICE
NOTICE
NOTICE
Rotary Type
23
ENGLISH
Loosen
Union Nut
Valve Shaft
Cap Nut
2
1
Valve Shaft
Vertical Type
Quick Beer Hose Joint
Cleaning Sponge
Keg Coupler
Publicidad
