[A] Larger Mug Setting; [B] Smaller Mug Setting; Dispensing; [A] Automatic Dispensing - Hoshizaki DBF-AS65WE-EU Manual De Instrucciones

The liquid and foam amounts are adjusted by visual check of dispensed beer and button operation. The set amounts vary with
the CO2 gas pressure. Readjustment is necessary every time the CO2 gas pressure is changed.
The setting is available for any two mug sizes. Place the larger mug on the lower platform and the smaller mug on the upper
platform. The larger mug must be at least 2 cm higher than the smaller mug.
The automatic dispensing is intended for a standard glass mug. To avoid excessive foaming, do not use a paper cup or
ceramic mug.
The set amounts may vary depending on the ambient temperature, beer keg temperature, use condition and remaining beer
level.
The tolerance of set amounts is about 30 mL per 400 mL mug. The CO2 gas pressure must be adjusted according to the beer
keg temperature. The set amounts may vary depending on the performance of the regulator controlling the CO2 gas pressure.
If the set amounts vary too much, the regulator must be replaced.
Empty the drain pan frequently before it overflows onto the floor. The cooling water inside the water tank absorbs moisture in
the air and flows through the overflow hose into the drain pan.

[a] LARGER MUG SETTING

1) Flip up the upper platform (accessory). Place a clean mug on the lower
platform (accessory) with its back against the wall.
2) Press the set button. The set lamp lights up and the dispense lamp
flashes.
3) Press and hold the dispense button to raise the platform up to an angle of
40 degrees.
4) While pressing the dispense button, press and hold the liquid button. When the desired amount of liquid is dispensed, release
the liquid button only. The platform stays at an angle.
5) While pressing the dispense button, choose how to move the platform back to the original position.
To move the platform while dispensing liquid, press and hold the liquid button for the desired dispensing duration.
To move the platform without dispensing liquid, press the stop button.
6) [If no foam is needed, skip step 6) and go to step 7).]
While pressing the dispense button, press and hold the foam button. When the desired amount of foam is dispensed, release
the foam button only. To add more foam, press the foam button again.
7) Release the dispense button to complete the larger mug setting. The set lamp goes off and
the dispense lamp stops flashing and stays on. If the setting fails to complete, go back to step 2).

[b] SMALLER MUG SETTING

1) Flip down the upper platform. Place a clean mug on the upper platform with its back against
the wall.
2) See steps 2) to 7) in "[a] LARGER MUG SETTING".

6. DISPENSING

Serve beer in accordance with the applicable local regulations.

[a] AUTOMATIC DISPENSING

1) Check that the beer tap is not dripping. Place a clean mug on the same platform as used for the setting.
IMPORTANT
IMPORTANT
17
Lower Platform
Upper Platform
ENGLISH
Upper Platform