Descargar Imprimir esta página

[B] Stopping Automatic Dispensing; [C] Manual Dispensing - Hoshizaki DBF-AS65WE-EU Manual De Instrucciones

Dispensador automático de cerveza de barril

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 132
ENGLISH
2) Press the dispense button. The unit automatically dispenses the set amount of liquid and
foam.
The mug tilting operation is factory set to "0: Yes" (mug is tilted while beer is being
dispensed).
3) To add more foam, press and hold the foam button until the desired amount of foam is
dispensed.
Place a mug on the platform after the beer tap stops dripping remaining foam.

[b] STOPPING AUTOMATIC DISPENSING

If power failure occurs during the dispensing operation and the operation panel unit is lifted up, do not pull it down by force
after power supply is resumed, but contact your dealer/supplier.
If the display shows an error code (E_ _), turn off the power supply and turn it back on. If the display still shows the error code,
contact your dealer/supplier.
To stop the automatic dispensing operation halfway through:
1) Press the stop button. The platform stops at that position.
When the stop button is pressed again, the platform goes back to the original position.
2) If the dispensing operation does not stop with the stop button pressed, lift up the operation panel unit. The
beer tap lever comes off the operation panel unit and goes back to the closed position. If beer still keeps
running, move the lever back and forth.
To reduce the risk of injury, do not put your fingers into the bottom opening of the operation panel unit while it
is lifted up.
3) Close the keg coupler attached to the beer keg. See "II. 3. [d] REPLACING BEER KEG".
To stop the automatic dispensing operation in case of power failure or error:
Follow steps 2) and 3) above.

[c] MANUAL DISPENSING

1) Lift up the operation panel unit slowly until it locks into place. The display shows "OFF".
2) To dispense beer, pull the beer tap lever quickly toward you until it stops. To avoid excessive
foaming, do not pull the lever slowly or stop it halfway. Release the lever to stop beer.
3) To dispense foam, push the beer tap lever quickly away from you until it
stops. To avoid liquid foam, do not stop the lever halfway. Release the lever
to stop foam.
Note: When the beer tap lever is pushed during manual dispensing
operation, the valve shaft end comes out. Be careful not to hit the mug
on the shaft.
IMPORTANT
IMPORTANT
IMPORTANT
CAUTION
18
Valve Shaft End
Mug

Publicidad

loading