Mounting The Profile Plate And The Control Console; Cable Connections - Festo MPS 8049013 Manual Del Usuario

11.3 Mounting the profile plate and the control console

11.4 Cable connections

© Festo Didactic 8049748
1 Profile plate
2 Hammer head nut, M6-32 (4 ea.)
3 Trolley
4 Serrated washer, J6.4 (4 ea.)
5 Washer, B-6.4 (4 ea.)
6 Socket head screw, M6x10 (4 ea.)
7 Sheet metal screw, 3.5x9 (2 ea.)
8 Control console
1 PLC board to station
If the SysLink 19" system plug module is
used: connect socket A to the SysLink
socket on the C interface using a SysLink
cable, or the SysLink socket at the
station's digital I/O terminal.
Note
In the case of the storage station,
the digital I/O terminal is mounted
to the motor controller board.
PLC board to control console
2
If the SysLink 19" system plug module is
used: using a SysLink cable, connect
socket B to the SysLink socket on the
control console.
PLC board to power supply unit
Insert the 4 mm safety plugs into the
sockets on the power supply unit.
PC to PLC
Connect your PC to the PLC via a
programming cable.
Storage station
55