5e
LM9225 ONLY: Install inside mounting plate.
Install mounting plate on
stop side (interior side).
5f
Hold the mortise chassis away from the pocket so that the cables
are slightly taut.
Turn the cable spool screw(s) clockwise.
For 2-point latch, alternate between top and bottom.
The mortise chassis will pull into the pocket.
Before the mortise chassis is completely inside the pocket,
check that the cable is not caught on the mortise chassis or a
spool cover.
Continue to turn the cable spool screw(s) clockwise (alternating
top and bottom for 2-point latch).
DO NOT OVERTIGHTEN!
Stop turning the spool screw(s) when the mortise chassis is
completely inside the door.
Additional adjustment will be done at a later step.
If clicking noises are heard during clockwise adjustment,
unwind the cable with one -half turn counter-clockwise. Then,
continue clockwise adjustment. If clicking persists, check that
cable is not caught on an edge or jammed at spool covers.
6
L The following steps are shown with rose trim. Escutcheon is
Posts down
6a
Attach mounting posts to the lever.
Place spring cage on the lever.
6b
Place the exterior lever assembly and the spindle and spring into
the door.
Escutcheon
trim
IMPORTANT
Check latch operation – top latch
installed in the same manner except where shown otherwise.
Assemble the exterior lever.
Do not fasten the exterior lever to the door at this time.
L Escutcheon
trim only
Fully tighten
mounting posts
on the screws.
The spring
cage arrows
must point in
direction of lever
down rotation.
Rose trim
8