Publicidad
Mark the bottom center point of each slot (e) and prepare door
frame as shown.
DO NOT DRILL THIRD HOLE AT THIS TIME.
e
10b
Install top strike.
Install two (2) top strike screws using the slot features on the
strike.
Typical installation requires
one thick and one thin
shim. Adjust as necessary.
150 Top Strike
Metal
Wood
Z\," (3.2 mm) drill
Pilot 1" deep x2
Metal
Center punch + Z\zn"
pilot holes
#25 x C\v" deep x2
#10-24
Wood
10c
Prepare floor for bottom strike (2-point latch only).
Chisel out pocket
¹⁄₂" deep
⁷⁄₈"
10d
Install bottom strike (2-point latch only).
Clear holes of debris, then drop in anchors (a), slotted end first.
a
Secure the anchors using a hammer and punch (b).
b
Install strike plate and secure with two (2) screws (c).
c
Latch
1¹⁄₄"
1"
1"
1"
³⁄₈" dia.
¹⁄₂"
x 1¹⁄₄" deep
2 places
Door Stop Side
IMPORTANT!
Anchors must be
below flush.
450 Bottom Strike
12
Publicidad
Capítulos
